e4 paramaters for Estlecam
Until i'm sure,,i don't want to use Estlcam on my E4, I've looked around for the specific parameters.
I'm at SETTINGS>CNC CONTROLLER>BASIC SETTINGS
Is there a link i'm missing? UGS is working well
Thanks Joe
-
the screen im referring to is in cnc settings,,i watched the estlecam vid on youtube where he writes to the board(arduino).
here is that link,,at 1:26
https://www.youtube.com/watch?v=_y4g8zBoOV0&index=5&list=PLqskLEz9H24T6kSPnQlbMIYHTe0fnfQUA
-
There is a BobsCNC E3 in the menu choices that will give you most of the values. You will need to change the X and Y travel distance in the homing tab.
However, you will need to change some jumper settings on the controller.
https://support.bobscnc.com/hc/en-us/articles/360011772374-Controller-setup-for-EstlCAM-Sender
-
This link wont allow me in
https://support.bobscnc.com/hc/en-us/articles/360011772374-Controller-setup-for-EstlCAM-Sender
Please sign in to leave a comment.
Comments
4 comments